4 cavity PET bottle blow molding machine

Advantages of the machine:

1. The whole machine is designed according to the linear high-speed machine, and the equipment is lengthened to ensure that the finished product rate is high, and it can be adapted to the rapid prototyping of various bottle shapes.

2. The aviation aluminum linkage structure is adopted to ensure that the whole machine will not be elongated due to the center distance during high-speed and long-term operation.

3. Adopting double crank arm mold clamping + high pressure mold clamping to make the mold clamping machine run more smoothly and at high speed, with large clamping force and small stitching line. The clamping machine is equipped with a lubricating oil distribution system, which can evenly supply the lubricating oil to the joints of the double-crank arm to better protect the double-crank arm

4. Servo stretching system and servo clamping system have the advantages of uniform stretching speed, good product forming, more stable performance, etc.

5. Adopting an extended ruby infrared oven with fine fire and slow roasting, which can make the preforms baked completely, and the temperature of the inner and outer surfaces is almost the same, which has ensured the rapid forming of the PET bottles, thereby increasing the output and the yield rate as high as 99.9%, easy to operate , There is no need to adjust the temperature of the oven frequently. The effect of lengthening is to save energy and increase the output. We use a lower temperature to slowly bake the tube embryos, while the ovens on the market are short, in order to bake the tube embryos to a certain extent. , It must be to increase the temperature of the lamp tube. This is the conclusion we reached after testing and comparing. The tube embryos baked like this must have different temperatures inside and outside, and the forming effect is not as good as ours.

6. Using ruby infrared lamp tube, the penetrating power is doubled than ordinary infrared lamp tube

7. A four-automatic bottle blowing mold with positioning function. It only takes 5 minutes to replace the mold. Because the machine template is provided with grooves, it can be positioned up, down, left, and right.